Wholesale jcb excavator parts manufacturer and supplier in Guangzhou

1. The starter and flywheel teeth are not meshed well. The ring gear and the starter gear collide when starting the engine, causing tooth damage or single-sided wear of the teeth. If more than three teeth are damaged or worn seriously, it will be difficult for the starter gear and the ring gear to mesh.

2. Cylinder sticking. When the engine temperature is too high, the engine is stopped and the heat is difficult to dissipate. The piston ring at high temperature sticks to the cylinder and cannot start after cooling.

3. Crankshaft lock. Due to lubrication system failure or lack of oil, the sliding bearing rubs dry, which eventually locks the crankshaft and cannot start.

4. The injection pump plunger is stuck.

8 reasons for the engine speed drop of the excavator, 6 solutions are here!

As the name suggests, engine speed drop means the failure of the engine speed drop during the operation of the excavator. There are two manifestations of speed drop, one is a slight speed drop within 200 revolutions, and the other is a serious speed drop above 300 revolutions, which is likely to cause the excavator to suddenly shut down. There are 8 main reasons for the engine speed drop of the excavator.

1. The diesel oil circuit of the excavator is faulty. Generally speaking, when the diesel oil circuit is blocked, it may cause the speed drop phenomenon.

2. The hydraulic system of the excavator has a fault, so that the hydraulic pump cannot change the displacement normally, causing the system pressure to be too high, and the speed drop may also cause a machine failure.

3. The output power of the excavator engine itself is insufficient, the output power is lower than the rated power, and the speed is too low. There is also a problem with the main pump.

4. The engine uses fuel of poor quality or the water content of the fuel is too high, which will lead to insufficient engine power and speed drop.

5. When the air intake system leaks or is blocked, the engine will be short of air supply, resulting in incomplete combustion of fuel, and there will be speed drop and black smoke failure.

6. Due to the large gap of the solenoid valve, the fuel supply is insufficient, which causes the engine to drop.

7. The joint of the fuel supply circuit of the fuel system is loose or the pipeline is broken, causing fuel leakage or foreign matter blockage, resulting in insufficient fuel supply. In addition to speed drop, it may also cause flameout.

8. There are many reasons for speed drop, such as incorrect valve clearance, wrong injection timing, damaged turbocharger, faulty brakes, etc.

Having said so many reasons for the speed drop of the excavator engine, what should we do when the speed drop occurs?
The solutions are all here!

1. First, check whether the diesel used in the excavator is deteriorated, whether there are impurities in the oil, and whether the oil circuit is blocked.

2. Check the valve clearance of the excavator engine and the speed of the engine.

3. Check the intake pipeline, clean the air pre-filter and air filter element, and start the engine again.

4. Check whether the speed drop of the excavator occurs when the engine is under load?

5. Carefully check the engine to see if the engine failure causes the speed drop of the excavator engine.

6. In addition, the electronic control, hydraulic system, fuel system, etc. need to be checked.

Possible electrical issues, low hydraulic oil level, clogged filter, or internal pump failure.

Solution: Check electrical connections, refill hydraulic oil, clean or replace filter, inspect and repair or replace pump.

Inspect the tracks, travel motors, and travel reducers. Test the pressure and flow of the hydraulic drive system, check if the control valves are functioning correctly, and perform necessary repairs or replacements.

Check the battery charge and connections, inspect the starter motor and ignition system, ensure the fuel system is supplying fuel properly, and read fault codes for further diagnostics.