Wholesale sumitomo excavator parts manufacturer and supplier in Guangzhou

If the engine has trouble starting, first check the battery charge and connections. Ensure the fuel system is supplying fuel by inspecting the fuel pump and fuel lines for blockages. Check the glow plugs (for diesel engines) or spark plugs (for gasoline engines) for wear and replace them if necessary. Use a diagnostic tool to check for any fault codes that might indicate issues with the engine control unit (ECU) or sensors.

Kobelco excavator maintenance tips 1: Cooling to prevent air blockage In high temperatures in summer, the engine is prone to air blockage due to high speed and difficult heat dissipation, which makes it difficult to start the engine after stopping for a few minutes. Once air blockage occurs, the excavator driver should stop the engine immediately to cool down and eliminate the fault.

Kobelco excavator maintenance tips 2: Observe the water temperature gauge at any time to prevent water shortage When driving in high temperature weather, always pay attention to checking the cooling water volume and the water temperature gauge. When water shortage is found, immediately idle the engine to cool down before adding water, and be careful not to open the radiator cap immediately to prevent burns.

Kobelco excavator maintenance tips 3: Prevent engine oil from deterioration Lubricating oil is easily diluted by heat, resulting in poor oxidation resistance, easy deterioration, and even causing faults such as burning of the bearing and the shaft. Therefore, the crankcase and gearbox should be replaced with summer lubricating oil, and the amount and quality of the lubricating oil should be checked frequently, and replaced in time.

Kobelco excavator summer maintenance tips 4: timely cleaning of engine surface oil If the external oil of the engine is too thick, it will affect the heat dissipation and bury the hidden danger of failure of various parts. You can use the high-pressure spray method to clean the engine parts with a cleaning agent that does not corrode the body parts.

Kobelco excavator summer maintenance tips 5: prevent the water tank water temperature from being too high In summer, the cooling water of Kobelco excavators evaporates and consumes quickly. You must add enough cooling water before leaving the vehicle, and check the water level frequently during work. For single-cylinder diesel engines without a water temperature gauge, always pay attention to the red mark height of the water tank float. If the float cannot be used normally, it should be repaired in time. If the boiling phenomenon occurs during work, do not add cooling water directly. Stop the work, slow down the generator, and slowly add cooling water after the water temperature drops to avoid cracks in the water tank when it is cold.

Kobelco excavator summer maintenance tips 6: Ensure the best oil supply time In summer, the oil supply time of Kobelco excavators should be adjusted. If the oil is supplied too early, the engine will make a knocking sound and sometimes reverse; the oil supply time should not be too late, otherwise the engine will work weakly.

When the battery liquid specific gravity is lower than 1.15 or the single cell voltage is lower than 1.7V (V), or when changing seasons for maintenance, it should be removed for recharging and the liquid specific gravity should be adjusted. If it needs to be parked for a long time, it should be fully charged and stored, and recharged once a month. If it needs to be stored for a long time, it should be fully charged, all the liquid should be poured out, and the filling port should be sealed for storage. When it needs to be used, re-add the electrolyte that meets the requirements.

Possible clogged filter, low hydraulic oil level, or worn pump components.

Solution: Clean or replace filter, refill hydraulic oil, inspect and replace worn components.

The pump housing will wear more in the oil inlet chamber. If the pump housing is symmetrical, it can be turned 180 degrees. Then use it. For the passive gear, the two ends cannot be replaced. Make a mark when removing it. Because the gear will wear on one side. The active gear is integrated with the rotating shaft and cannot be turned over; turning the passive gear over can change the contact point of the meshing line of the two gears. After the pump is assembled, add a little lubricating oil and rotate it slightly by hand. The feel should be smooth.